Anemo Engineering is an official distributor of camloc parts and supplies camloc quarter turns and latches all around the globe.

This website is designed to help engineers in the UK to determine the correct camloc quarter turn.

Each tool has notches where the protruding insert kees fit to enable effective winding in of the insert.

Once the insert is fully wound in, the tool can be pulled back and turned 45 degrees, so the kees are situated between the notches, and driven down through the threads of the parent material, mechanically locking it into place.

They can be used for thread repair, if the defected thread has to be replaced with the same nominal diameter.

Keenserts s are standard available in stainless steel and have 2 or 4 pre-assembled kees according to the dimensions.

After installation of the kees into the parent material the assembly is form-closed.

No check with a thread gauge according to DIN standard is possible in the area of the kees.

Due to these kees Keenserts s have a positive lock against rotation and vibration.

Keenserts Inserts give high strength joints in low strength materials.

Typical applications are transmission housings, electronic equipment and suspension units.

Keenserts s inserts are divided in 3 major families: - Miniature Keenserts - Lightweight Keenserts - Heavy duty Keenserts There are always 2 versions available of a Keenserts: the standard version or the locking version.

Each Keenserts has its own installation tool which are also available at Anemo engineering.

It is possible to purchase complete tooling sets, which contain all required tools for installation.

Carbon steel keenserts are no longer manufactured but have been replaced by keyserts a sister company of camloc is making them, advised minimum quantity 500 pieces (carbon steel C1215 or equivalent; kees are stainless steel).

Turn the Keenserts in the tapped hole to just below the surface of the piece.

Do this by knocking with a hammer on the Keenserts installation device.

An identical insert can now be installed in the original hole.

Would you like technical advice and support for your product - Contact an Engineer.

Keenserts Installation Tools